|
|
Post by rallyfinnen on Nov 10, 2009 14:16:34 GMT -5
Bought some rubber bellow (for rc-boats)and used it to protect the throttle shaft on the carb.   The shaft has developed a little play because of dirt. I forgot to put an o-ring on this carb as I did before on the FS carb.. This was the quick and dirty way, no need to remove the carb and throttle valve.. |
|
sickboy
Full Member
hey hook me up with another fs www.fshopups.com
Posts: 187
|
Post by sickboy on Nov 10, 2009 14:32:41 GMT -5
ye that looks good
my mate has had the same problem to but with a w813 carb well he ended up using a o ring form a shock but before he mounted this to his carb link he made some room so that the O ring would sit in its place i should say he counter sunk into the carb with a steel washer holding it in place and ever since hes had no problems
if i get to see him in the near future then i will post up a few picks
|
|
|
|
Post by rallyfinnen on Nov 11, 2009 3:37:36 GMT -5
I think I know what you mean. Remove the throttle shaft and enlarge the end of the hole for the shaft to fit a o-ring to seal it.
Would also help to remove some play if it is worn...
|
|
|
|
Post by rallyfinnen on Nov 15, 2009 3:58:35 GMT -5
I swapped engine in the car yesterday, and since I moved over the carb to the CF engine, I did the o-ring sealing on the throttle shaft too. I will post the pics later.
|
|
|
|
Post by rallyfinnen on Nov 16, 2009 7:02:02 GMT -5
Here are some pics of the mod.. Washer and o-ring    I also put the bellow on as I did in the first post, so now I have double protection  |
|
